Installation Instructions
For Part Numbers:
200-996 Modular Intake Tube
200-796 Jr. Kit 850-135 Airaid Oiled Media Filter
201-796 Jr. Kit 851-135 SynthaMax Dry Media Filter - Red
202-796 Jr. Kit 852-135 SynthaMax Dry Media Filter - Black
203-796 Jr. Kit 853-135 SynthaMax Dry Media Filter - Blue
Component Identification
1. *Airaid Premium Filter 1
2. Modular Intake Tube 1
3. Urethane Hump Hose 1
4. Silicone Coupler 1
5. 3/8” x 14” Breather Hose 1
6. #60 Hose Clamp 2
7. #64 Hose Clamp 2
8. 1/4”NPT x 3/8” Barb Fit. 1
* Filter included only in Jr. Kits
1. Disconnect the negative battery cable.
Remove the factory beauty cover by lifting up on the front, and then pull-
ing the cover towards the front of the vehicle. It is only held in place by
grommets.
2. Disconnect the factory breather hose at the valve cover.
3. Separate the factory intake tube from the plastic clamp barb that secures
the radiator hose to the tube. A firm downward push will usually do it.
4. Loosen two hose clamps on the factory intake tube. One at the throt-
tle body end, and the other at the Mass Air Flow sensor (MAF) end.
Mass Air Flow sensor
2007-13 Cadillac Escalade
2007-12 Cadillac Escalade ESV/EXT
2007-13 Chevrolet Avalanche/Silverado 1500
2007-13 Chevrolet Tahoe/Suburban 1500
2007-13 GMC Sierra 1500/Yukon/Yukon XL 1500
4.8L V8, 5.3L V8, 6.0L V8*, 6.2L V8
*With Electric Cooling Fans Only
*Does not fit 6.0L motors after 2010
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.
5. Slide the factory intake tube off of the MAF sensor, rotate it up so that
it disengages from the mounting grommet on the intake manifold, and then
slide it forward off of the throttle body and remove it from the vehicle.
6. Install the silicone coupler (#4) on the throttle body end of the Modu-
lar Intake Tube (#2) with two #60 hose clamps (#6). Install the urethane
hump hose (#3) on the other end of the MIT with two #64 hose clamps
(#7). Leave all clamps loose for now. Install the 3/8” barbed fitting (#8)
into the MIT, and slide the 3/8” breather hose (#5) over the barbed fitting
as shown.
Kommentare zu diesen Handbüchern