Parts List
#1 Poweraid Spacer x1
#2 6mmx63mm Bolt x4
#3 6mmx70mm Bolt x4
#4 6mm Flat Washer x4
#5 O-Ring x1
Tools Required For Installation
5/16”, 10mm Socket
Ratchet , Extension and a Ruler
Installation Instructions
Part Number 300-631-1
2009-15 Dodge Ram
2009 Chrysler Aspen
2009 Dodge Durango
5.7L V8
1. Disconnect the negative battery cable!
Disconnect the air intake temperature sensor wiring harness by
sliding the red tab, and then squeezing the black tab.
Loosen two hose clamps, one on each end of the flexible air
intake tube. Remove the tube from the vehicle.
Lift straight up on the front of engine cover, pull it towards you,
and set it aside.
Thank you for purchasing the Poweraid Throttle Body Spacer. Contact AIRAID @ (800) 498-6951 8:00 AM - 5:00 PM MST
Weekdays for questions regarding fit or instructions that are not clear to you. Your Poweraid Throttle Body Spacer was carefully
inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, please con-
tact AIRAID.
2. Remove the four bolts that secure the throttlebody to the
intake manifold. Without disconnecting the wiring harness,
remove the throttlebody from the intake manifold and set it
aside.
CAUTION!
This kit contains Two different
sets of mounting hardware.
Successful installation of this part requires
proper identification of the OEM Throttle
Body hardware to prevent severe intake man-
ifold damage.
Please read these instructions in their entirety
before beginning the installation.
Kommentare zu diesen Handbüchern