Airaid 450-613 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Zubehör für die Luft Airaid 450-613 herunter. Airaid 450-613 User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 2
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
1. Disconnect the negative battery cable!
Using a 5/16” socket, loosen two hose clamps that
hold the intake tube between the throttle body, and the
air cleaner lid.
Turn the green tab, and disconnect the breather hose
from the air intake tube. Remove the intake tube from
the vehicle.
2. Using a 5/16” socket, remove the 4 bolts that hold
the throttle body to the intake manifold.
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the in-
struction manual carefully before proceeding with the installation. Contact AIRAID @ (800)
498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that
are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact AIRAID.
Thank you for selecting AIRAID.
Parts List
#1 Poweraid Spacer x1
#2 6mmx65mm Bolts x4
#3 6mm Flat Washers x4
#4 Fiber Gasket x1
Tools Required For Installation
5/16”, 10mm Sockets
Ratchet and Extension
Installation Instructions
Part Number 450-613
Poweraid Spacer For
2005-10 Ford Mustang
4.0L V-6
Included with your Poweraid Spacer is a sticker with a California Air Resources Board
(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of
the engine compartment. Failure to do so may prevent you from passing a smog inspection.
The C.A.R.B. E.O. number for this part number
includes the vehicles listed above thru the 2009
model year. All others are pending.
Seitenansicht 0
1 2

Inhaltsverzeichnis

Seite 1

1. Disconnect the negative battery cable! Using a 5/16” socket, loosen two hose clamps that hold the intake tube between the throttle body, and the

Seite 2 - Washers

4. Reinstall the intake tube, and tighten the hose clamps. Reconnect the breather hose to the intake tube. 6. Re-connect the negative battery cable!

Kommentare zu diesen Handbüchern

Keine Kommentare