10. Install the supplied grommet (#16), into
the Airaid Intake Tube (#2)
11. Install the factory fitting from step #7 into
the grommet (#16) from step #10.
12. Install the MAF sensor from step #5 into
the Airaid Intake Tube. Use the two supplied 8
-32 button head bolts (#10), to securely fasten
the MAF sensor.
Do Not Use The Factory Screws!
13. Install the urethane hump hose (#4) on
the filter adapter (#5) with two #72 hose
clamps (#13). Next install the reducing cou-
pler (#3) small end first, onto the throttle
body with one #48 hose clamp (#11), and
one #52 hose clamp (#12). Leave clamps
loose.
14. Install the Airaid Intake Tube into the hump
hose first, and then into the reducing coupler,
adjust for fit, and then tighten the four hose
clamps. Reconnect the breather hose, and the
wiring harness to the MAF sensor.
15. Install the Airaid Premium Filter (#1)
onto the filter adapter (#5). Next install the
weather strip (#7) on the top of the CAD as
shown. Start at the front of the CAD and
work towards the rear.
16. Double check your work!
Make sure there is no foreign material in the intake path. Make sure all clamps, hoses, bolts,
and screws are tight. Double check the hood clearance.
17. Reconnect the negative battery cable!
Airaid Filter Co. 26
88 E Rose Garden Ln. P
hoenix AZ 85050
(800) 498
-6951 [email protected]m www.airaid.com REV.10.24.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is
reusable and should be cleaned periodically.
FILTER IDENTIFICATION
700-466 Airaid Oiled Media 701-466 Airaid SynthaMax Dry Media - Red
702-466 Airaid SynthaMax Dry Media - Black 703-466 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall.
(2 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern