10. Double check your work!
Make sure there is no foreign material in the intake path.
Make sure all clamps, hoses, bolts, and screws are tight.
11. Re-connect the negative battery cable!
Airaid Filter Co. 26
88 E Rose Garden Ln. P
hoenix AZ 85050
(800) 498
-6951 [email protected] www.airaid.
com
REV.03.25.14
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is
reusable and should be cleaned periodically.
9. Install the MIT onto the MAF first, and then onto the throttle body.
Adjust for fit, and tighten the hose clamps. Next connect the breather
hose to the factory breather port on the valve cover. Reinstall the factory
hose clamp barb back into the hole in the bottom of the MIT. Reinstall
the beauty cover.
7. If you purchased the 200-996 kit, proceed to step # 9. If you pur-
chased a Jr. Kit, remove 4 screws in the factory airbox with a #25 Torx
bit, and remove the factory air filter. Proceed to step #8.
8. Install the Airaid Premium filter (#1) into the factory airbox, and re-
install the 4 screws.
FILTER IDENTIFICATION
850-135 Airaid Oiled Media 851-135 Airaid SynthaMax Dry Media - Red
852-135 Airaid SynthaMax Dry Media - Black 853-135 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall.
WARNING! If your vehicle has a Vehicle Emission Control Information decal affixed to the factory airbox, a
new replacement label must be obtained and installed in a readily visible position in the engine compartment in
order to remain CARB compliant. Failure to do so will prevent the vehicle from passing a smog check. Replace-
ment labels can be ordered from your local dealership. Regulations state that the VECI label shall not be affixed
to any equipment which is easily detached from the vehicle. Label placement, under the hood on a painted sur-
face is recommended.
(2 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern